We'll start this post with the last image from the previous post. A top view of the 128-channel D/A Convertor and 8 voice synthesizer rack cage.

The front panel is at the bottom, digital back-plane is visible at top-left. The nest of wires at top-right were the signals routed to the mixer/effect cage. The latter already removed at this disassembly stage. The eight RSF-KOBOL Expander I synthesizer boards are at right.
When we unbolt the 12 screws holding the font panel to the frame, the wire guts spill out. Getting this crammed in was indeed blood, sweat and tears. It actually took two attempts to develop a solution that allowed sufficient space to close the front. It is this amount of connectors and cabling that forced me to offset the 100mm x 160mm boards, a "euro" size, deeper into the case. Testament to that is the need to offset the bus back-plane, visible at left, deeper into the case with nylon standoffs.

Each sample and hold card (S&H) is connected to an RSF-KOBOL Expander I board with a custom 16 pin flat-cable. That took care of one aspect. The 3.5mm jack section on the front panel is wired into the system via 10 flat-cables and and an equal number of shielded audio lines.
The majority of the 3.5mm jacks are normalized. The switching pin contact is connected to a source, in such a way that when a jack is inserted, the normalized connection is interrupted. This is standard practice in modular voice synthesis setups. It allows for a sensible signal path with a minimum of patch-cords.
The rainbow flat-cable in the front carries the individual computer generated GATE signals from the Apple II interface board, generated locally by a 74259 style 8-bit addressable latch chip. The yellow wire in the front, snaking through the top row of jacks, is the monophonic KEYBOARD signal coming from the rear of the case.
A rats niest, for sure, but this was a one-off prototype with no room for revision two. This is all pre accessible CAD design, the PC was not invented yet.

The 16 channel rainbow wire from the RSF-KOBL carried most of the signals for tje 3.5mm jacks, most of them in turn normalized to some signal coming from the rest of the machine.
Tje greu flat-cable with red stripe carried the analog control voltages. Above image shows in little more detail how this was routed into the RSF-KOBOL boards.
This represented a lot of effort for a small, but practical and useful patch-panel.

Next photo shows how the signal cables emanate from the sample and hold boards. All these cables were hand made by pressing the flat-cable in the self piercing sockets using a vise. Never had the custom tools for this and with some practice, a vise achieved the same result.
At the right hond side of above image, there are two copper clad boards used as a vertical channel and shield to route some of the wires through. A matter of physical separation, protection and shielding.
In next episode, we'll take a look at more individual boards as part of dismantling the unit, but this is also in part a reverse documentation process, something I was not very good at during development. All designes lived in my head and only small key sections were documented in notebooks on an as-needed basis.